5TAHU 5 Ton Portable Industrial Air Handler Rental​

Type : Up flow Air Handler Chilled Water (2-pipe); Cooling/Size : 5 Tons CFM Range: 1800-2200; STD. Motor HP: 1-1/2-2, Direct Drive Motor Entering Water Temp {F}: 42-50; GPM: 7-13; Copper tube coils Temp Rise @ 80F: 10.4-14.2 w/45F Entering Water Manifold Connection : 1-1/8" O/D (SWT) Water Supply/Return Connection Size: 1.5"/1.5" QC Voltage/Ph : 120V/1, 3/4-10.5 Amps 3-Speed {Low, Med., High} Blower Size: 15" x 15"; 1-20" Supply/1-20" Return Filter Size: 20" x 25" x 1" Throw Away Condensate Pump Included, Convertible horizontal drain pan Rental Dimensions: Length: 36"/Width: 36"/Height: 54"/Weight: 500 lbs Insurance Value: $10,000.00

---

5 Ton Portable Industrial Air Handler Rental

CABINET -
Fabricated of heavy gauge galvanized steel. Seismic resistant mounting brackets are standard on 2-5 ton models.
BLOWER -
Resiliently mounted, heavy duty, double inlet, forward curved blade, centrifugal type. Each wheel is dynamically balanced for smooth, quiet operation. All blowers are belt driven with field
adjustable pulleys to permit variations in static pressure and air requirements. All blowers have ball bearings.
COILS -
Fabricated of 3/8” or 1/2” OD seamless copper tubes mechanically expanded to highly efficient aluminum fins to maximize heat transfer. All coils have manual air vents. All models have positive
slope drain pans.
INSULATION -
The entire interior of the cabinet is insulated with one (1) inch insulation.
FILTER -
One inch throw away filters are provided as standard in all 2 - 5 ton units. One inch permanent filters are provided as standard in all 7-1/2 - 20 ton units. Filters can be changed without tools.
Space available for 2”.

​​FACTORY WIRED -
All standard motors are field or factory installed and wired at voltage specified by customer. (If not specified, multi-voltage motors will be wired at highest voltage)
MOTOR -
Standard motor is 1725 RPM. The adjustable motor mount permits easy belt adjustment. A variable pitch pulley allows balancing of the system to the desired CFM. Standard motors
have internal overload protection. Therefore, units shipped with standard motors will be ETL listed. Most non-standard motors (i.e. 575V, 2-speed, TEFC, some 50 Hz., etc.) are not available
with internal overload protection. Therefore, most units shipped with non-standard motors can be ETL listed with the addition of a factory installed motor starter (contact the factory for starter
information and ETL verification.)
MISCELLANEOUS -
- Slotted mounting rails for easy installation (2 -5 ton SHW only). Rails are turned down 1/2” on each end for safer and easier installation.
- 4 x 4 junction box accepts a field installed (24/120V) relay / transformer for low voltage control.
- 3/4 inch NPT drain connections on both sides of cabinet.
- Header connections on the right side as standard. Knockouts are provided for conversion to the left side. (Looking with air flow).
- Drain pans are coated for corrosion protection.

BACK TO EQUIPMENT PAGE